When can I use cyclone, rotary cyclone and cartridge recovery?
Please refer comparison chart.

What is the difference between single cyclone and rotary cyclone?
In the Rotary Cyclone the amount of air handled by a single cyclone is divided among number of small cyclones place in the series. By doing so we can reduce height required for the cyclone. Air enters tangentially in the single cyclone while Mitsuba Rotary cyclone has axial entry with Rotary Vanes at the entry of each cyclone which provides extra spin to create the high centrifugal force, which in turn increases the collection efficiency of rotary cyclone.

How is it ductless?
Air enters in cyclone axially and not tangentially as conventional cyclone. Axial entry does not require a duct for air. This makes rotary cyclone a ductless cyclone.

What is the advantage of ductless cyclone?
In a recovery system the duct is the most difficult part to clean. By eliminating the duct; colour change time can be reduced drastically.

What is the After Filter and why do I need it?
Either you can allow the finer residual powder escaping form cyclone out to the open atmosphere or you can recollect the same. The After Filter collects finer powder escaping out of the cyclone. Decision to install the same depends on your company’s environmental policy and local environmental laws. Please refer the section on the After Filter for complete details.

Can you replace my existing booth and recovery?
Yes, we can.

What data do you need to offer the solution?
We need sizes of the products to be coated, conveyor speed, entry-exit cut out of the booth and the number of colours you will operate.

The booth size as per my requirement is not there in the chart?
Kindly provide all the data; we will design a booth especially for you.

For more questions see the complete FAQ section.